CARE & INSTRUCTIONS

GETTING STARTED

To access your Torx bits, slide the storage compartment button to the left to open. Place your T30 (red) or T40 (blue) Torx bit into the bit port. Set the ratchet direction switch to your preferred mode (tighten, neutral, or loosen). 

USING YOUR FOILM8

Dry your hands before use for a secure grip. When starting a new bolt, ensure the correct ratchet direction is engaged and hold the bit port or bolt steady while ratcheting. Rotate clockwise to tighten, anti-clockwise to loosen. Adjust the 180° pivoting head for access in tight spaces or extra leverage.

The FOILM8 is intended for assembly on land only. It is not intended for in-water use.

BIT STORAGE

After each session, return your bits to the built-in handle storage compartment to keep them secure and ready for your next session. Avoid leaving screw bits in the bit port between uses.

CARE & MAINTENANCE

- Dry thoroughly between sessions
- Keep the bit port dry between uses
- Apply a light spray of a multi-purpose liquid or gel lubricant into the bit port periodically to keep your FOILM8 performing at its best

REPLACEMENT PARTS

Where a product is confirmed to be faulty, damaged, or incorrectly supplied, Hydroset will cover reasonable return shipping costs. Replacement T30 and T40 Torx bits are available separately. Contact us at info@hydroset.com.au and we'll get back to you.